This article does not cite any references or sources. Please help improve this article by adding citations to reliable sources. Unsourced material may be challenged and removed. (December 2007)

Giffard steam water injector (B-needle valve).

A needle valve.

A needle valve is a type of valve having a small port and a threaded, needle-like disc. It allows precise regulation of flow, although it is generally only capable of relatively low flow rates.

[edit] Construction and operation

A needle valve has a relatively small orifice with a long, tapered, conical seat.

A needle-shaped plunger, on the end of a screw, exactly fits this seat.

As the screw is turned and the plunger retracted, flow between the seat and the plunger is possible; however, until the plunger is completely retracted the fluid flow is significantly impeded. Since it takes many turns of the fine-threaded screw to retract the plunger, precise regulation of the flow rate is possible.

The virtue of the needle valve is from the vernier effect of the ration between the needle's length and its diameter, or the difference in diameter between needle and seat. A long travel axially (the control input) makes for a very small and precise change radially (affecting the resultant flow).

[edit] Uses

Needle valves are usually used in flow metering applications, especially when a constant, calibrated, low flow rate must be maintained for some time, such as the idle fuel flow in a carburetor.

Note that the float valve of a carburetor (controlling the fuel level within the carburetor) is not a needle valve, although it is commonly described as one. It uses a bluntly conical needle, but it seats against a square-edged seat rather than a matching cone. The intention here is to obtain a well-defined seat between two narrow mating surfaces, giving firm shutoff of the flow from only a light float pressure.

Since flow rates are low and many turns of the valve stem are required to completely open or close, needle valves are not used for simple shutoff applications.

Since the orifice is small and the force advantage of the fine-threaded stem is high, needle valves are usually easy to shut off completely, with merely "finger tight" pressure. Small, simple needle valves are often used as bleed valves in hot water heating applications.

Unlike a ball valve, or valves with a rising stem, it is not easy to tell from examining the handle position whether the valve is open or closed.

[edit] See also

• Ball valve
• Butterfly valve
• Control valve
• Flow limiter
• Gate valve
• Globe valve
• Mass flow controller
• Plastic pressure pipe systems
• Valve

This technology-related article is a stub. You can help Wikipedia by expanding it. v • d • e