Energy recycling is the energy recovery process of utilizing energy that would normally be wasted, usually by converting it into electricity or thermal energy. Undertaken at manufacturing facilities, power plants, and large institutions such as hospitals and universities, it significantly increases efficiency, thereby reducing energy costs and greenhouse gas pollution simultaneously. The process is noted for its potential to mitigate global warming profitably.^[1] This work is usually done in the form of combined heat and power (also called cogeneration) or waste heat recovery.

Contents 1 Forms of energy recycling 2 Current system 3 History 4 References

[edit] Forms of energy recycling

Waste heat recovery is a process that captures excess heat that would normally be discharged at manufacturing facilities and converts it into electricity and steam. A "waste heat recovery boiler" contains a series of water-filled tubes placed throughout the area where heat is released. When high-temperature heat meets the boiler, steam is produced, which in turn powers a turbine that creates electricity. This process is similar to that of other fired boilers, but in this case, waste heat replaces a traditional flame. No fossil fuels are used in this process. Metals, glass, pulp and paper, silicon and other production plants are typical locations where waste heat recovery can be effective.^[2]

Combined heat and power (CHP), also called cogeneration, is, according to the U.S. Environmental Protection Agency, “an efficient, clean, and reliable approach to generating electricity and heat energy from a single fuel source. By installing a CHP system designed to meet the thermal and electrical base loads of a facility, CHP can greatly increase the facility's operational efficiency and decrease energy costs. At the same time, CHP reduces the emission of greenhouse gases, which contribute to global climate change.” When electricity is produced on-site with a CHP plant, excess heat is recycled to produce both processed heat and additional power.^[3][4]

[edit] Current system

Both waste heat recovery and CHP constitute "decentralized" energy production, which is in contrast to traditional "centralized" power generated at large power plants run by regional utilities.^[5] The “centralized” system has an average efficiency of 34 percent, requiring about three units of fuel to produce one unit of power.^[6] By capturing both heat and power, CHP and waste heat recovery projects have higher efficiencies.

A 2007 Department of Energy study found the potential for 135,000 megawatts of CHP in the U.S.,^[7] and a Lawrence Berkley National Laboratory study identified about 64,000 megawatts that could be obtained from industrial waste energy, not counting CHP.^[8] These studies suggest about 200,000 megawatts -- or 20% -- of total power capacity that could come from energy recycling in the U.S. Widespread use of energy recycling could therefore reduce global warming emissions by an estimated 20 percent.^[9] Indeed, as of 2005, about 42 percent of U.S. greenhouse gas pollution came from the production of electricity and 27 percent from the production of heat.^[10][11]

Advocates contend that recycled energy costs less and has lower emissions than most other energy options in current use.^[12]

[edit] History

Perhaps the first modern use of energy recycling was done by Thomas Edison. His 1882 Pearl Street Station, the world’s first commercial power plant, was a CHP plant, producing both electricity and thermal energy while using waste heat to warm neighboring buildings.^[13] Recycling allowed Edison’s plant to achieve approximately 50 percent efficiency.

By the early 1900s, regulations emerged to promote rural electrification through the construction of centralized plants managed by regional utilities. These regulations not only promoted electrification throughout the countryside, but they also discouraged decentralized power generation, such as CHP. They even went so far as to make it illegal for non-utilities to sell power.^[14]

By 1978, Congress recognized that efficiency at central power plants had stagnated and sought to encourage improved efficiency with the Public Utility Regulatory Policies Act (PURPA), which encouraged utilities to buy power from other energy producers. CHP plants proliferated, soon producing about 8 percent of all energy in the U.S.^[15] However, the bill left implementation and enforcement up to individual states, resulting in little or nothing being done in many parts of the country.

In 2008 Tom Casten, chairman of Recycled Energy Development, said that "We think we could make about 19 to 20 percent of U.S. electricity with heat that is currently thrown away by industry."^[16]

Outside the U.S., energy recycling is more common. Denmark is probably the most active energy recycler, obtaining about 55% of its energy from CHP and waste heat recovery. Other large countries, including Germany, Russia, and India, also obtain a much higher share of their energy from decentralized sources.^[16][17]

[edit] References

v • d • e Topics related to environmental technology Environmental impact assessment · Environmental design · Sustainable development Pollution Industrial ecology · Solid waste treatment · Waste management  · Air pollution (control · dispersion modeling) · Water (Wastewater treatment · Agricultural wastewater treatment · Industrial wastewater treatment · Water purification) Renewable energy Alternative energy · Energy development · Energy recovery · Energy efficiency · Renewable energy (development) · Sustainable energy · Fuel (Alternative fuel · Biofuel · Hydrogen technologies) · Transportation (Electric vehicle · Hybrid vehicle) Conservation Birth control · Permaculture · Conservation ethic · Recycling · Ecoforestry · Conservation biology · Environmental preservation · Remediation · Green computing · Building (Green · Natural · Sustainable architecture)