add site
services
publishers
database
health videos
toolbar
stats
live show
health store
more stuff
JOIN/LOGIN
| advertise add site services publishers database health videos
| | about toolbar stats live show health store more stuff JOIN/LOGIN |
 .303 British, or 7.7mmx56R, is a .311 inch calibre rifle and machine gun cartridge first developed in Britain in the 1880s as a blackpowder round, later adapted to use cordite and then smokeless powder propellant. It was the standard British and Commonwealth military cartridge from 1889 until the 1950s when it was replaced by the 7.62x51mm NATO. The measurement .303-inch (7.7 mm) is the nominal size of the bore measured between the lands which follows the older blackpowder nomenclature. Measured between the grooves, the nominal size of the bore is .311-inch (7.9 mm). Bores for many .303 military surplus rifles are often found ranging from around .309-inch (7.8 mm) up to .318-inch (8.1 mm). Recommended bullet diameter for standard .303 cartridges is .312-inch (7.9 mm).[2] This cartridge has seen much sporting use with surplus military rifles, especially in Australia, Canada, New Zealand and to a lesser extent, in the United States and South Africa. In Canada, it was found to be adequate for any game except the great bears. In Australia, it was common for military rifles to be re-barreled in .303/25 and .303/22. In South Africa .303 British Lee Enfield rifles captured by the Boers during the Boer War were sporterized and became popular with many hunters of non-dangerous game, being regarded as adequate for anything from the relatively small Impala, to the massive Eland and Kudu.[3]
[edit] Marks 3, 4, 5, 6The round-nosed bullet was found to be unsatisfactory when used in combat, particularly when compared to the dum-dum rounds issued in limited numbers in 1897 during the Chitral and Tirah expeditions of 1897/98 on the North West Frontier of India. This led to the introduction of the Cartridge S.A. Ball .303 inch Cordite Mark 3, basically the original 215-grain (13.9 g) bullet with the jacketing cut back to expose the lead in the nose. Similar hollow-point bullets were used in the Mark 4 and 5 rounds, the primary production versions. These highly effective soft-nosed and hollow-point bullets were later prohibited by the Hague Convention of 1899. The expanding bullets were withdrawn from active service, where the remaining stocks (over 45 million) were used for target practice. To replace them the Mark 6 round was introduced in 1904, using a round nose bullet similar to the Mark 2 but with a thinner jacket, in the hopes that it might provide some expansion, though this proved not to be the case.[4][5] [edit] Mark 7In 1905 Mauser revolutionised bullet design with the introduction of pointed "spitzer" rounds. In addition to being pointed, the round was also much lighter in order to deliver a higher muzzle velocity. It was found that as velocity increased the bullets suddenly became much more deadly. In 1910, the British took the opportunity to replace their Mark 6 rounds with a more modern design. The Mark 7 (Mark VII) used a 174-grain (11.3 g) pointed bullet with a flat-base which gave a muzzle velocity of 2,440 ft/s (740 m/s).[6] The Mark 7 was different from earlier .303 bullet designs or spitzer projectiles in general. Although the Mark 7 round looks like a conventional full metal jacket bullet, this appearance is deceptive: its designers deliberately made the front third of the interior of the Mark 7 bullet out of aluminium or tenite (cellulosic plastic),or packed paper, instead of lead. This shifted the centre of gravity of the bullet towards the rear, making it tail heavy. Although the bullet was stable in flight due to the gyroscopic forces imposed on it by the rifling of the barrel, it behaved very differently upon hitting the target. As soon as the bullet hit the target and decelerated, its heavier lead base caused it to yaw violently and deform, thereby inflicting more severe gunshot wounds than a standard spitzer design.[7] In spite of this, the bullet was legal according to the terms of the Hague Convention. The Mark 7 (and later Mark 8) rounds have versions utilizing nitrocellulose propellants. The nitrocellulose versions—first introduced in World War I—were designated with a "Z" postfix indicated after the type (e.g. Mark VIIZ, with a weight of 175 grains) and in headstamps. [8] Perhaps the most famous single .303 British round ever fired was on 21 April 1918, during the Great War, when Manfred von Richthofen, the famed "Red Baron" flying ace, was mortally wounded by a single .303 Mk 7 round.[9] The shot was most likely fired by Captain Roy Brown (RAF officer), although an Australian Vickers machine gun crew on the ground also claimed credit for the kill. [edit] Mark 8In 1938 the Mark 8 (Mark VIII and Mark VIIIz) round was approved to obtain greater range from the Vickers machine gun.[10] Slightly heavier than Mk 7 ammunition at 175 grains (11.3 g), the primary difference was the addition of a boat-tail and more propellant (41 grains of nitrocelluose powder in the case of the Mk VIIIz), giving a muzzle velocity of 2,525–2,900 ft/s (780–884 m/s). As a result, the chamber pressure was significantly higher, at 42,000–60,000 lbf/sq in (approximately 280–414 MPa), depending upon loading, compared to the 39,000 lbf/sq in of the Mark VII round.[11] Cross-sectional images of Mk 8 ammunition indicate that its boat-tail bullet was long and gently tapered, providing a very high ballistic coefficient. Mk 8 ammunition was described as being for "All suitably-sighted .303-inch small arms and machine guns" but caused significant bore erosion in weapons formerly using Mk VII cordite, ascribed to the channelling effect of the boat-tail projectile. As a result it was prohibited from general use with rifles and light machine guns, except in an emergency where no other ammunition was available.[12] As a somewhat natural reaction to this official prohibition, ordnance personnel reported that every man that could get his hands on Mk 8 ammunition promptly used it in his own rifle.[10] [edit] Tracer, armour-piercing and incendiaryTracer and armour-piercing cartridges were introduced during 1915. Explosive bullets of the Pomeroy design as Mark VII.Y in 1916. Several incendiaries were privately developed from 1914 to counter the Zeppelin threat, but none were approved until the Brock design late in 1916 as BIK Mark VII.K [13] Wing Cmdr. Brock RNVR was a member of the Brock fireworks-making family. These rounds were extensively developed over the years and saw several Mark numbers. The last tracer round introduced into British service was the G Mark 8 in 1945, the last armour-piercing round was the W Mark 1Z in 1945, and the last incendiary round was the B Mark 7 in 1942. Explosive bullets were not produced in the UK after 1933 due to the relatively small amount of explosive that could be contained in the bullet, limiting their effectiveness, their role being successfully fulfilled by the use of Mark 6 and 7 incendiary bullets. In 1935 the .303 O Mark 1 Observing round was introduced for use in machine guns. The bullet to this round was designed to break up with a puff of smoke on impact. The later Mark 6 and 7 incendiary rounds could also be used in this role if required. During World War I British factories alone produced 7,000,000,000,000 rounds of .303 ammunition. Factories in other countries added greatly to this total.[14] [edit] Japanese 7.7 mm ammunition Japan produced a number of machine guns that were direct copies of the British Lewis and Vickers machine guns (Japanese Type 92 machine gun and Type 97 machine gun respectively) including the ammunition. These were primarily used in Navy aircraft. The 7.7mm cartridge used by the Japanese versions of the British guns is a direct copy of the .303 British (7.7x56R) rimmed cartridge and is distinctly different from the 7.7x58mm Arisaka rimless cartridge used in other Japanese machine guns and rifles.[15]
Note: standard Japanese ball ammunition was very similar to the British Mk 7 cartridge. Both had identical bullet weights and a "tail-heavy" design, as can be seen in the cut-away diagram. [edit] Military surplus ammunitionMilitary surplus .303 British ammunition is often available, notably at gun shows and from online dealers. It may or may not have corrosive primers. Care must be taken to identify the round properly before purchase or loading into weapons. Cartridges with the Roman numeral VIII on the headstamp are the Mark 8 round, specifically designed for use in Vickers machine guns. Although Mark 8 ammunition works well in a Vickers gun, it should not be used in rifles because the boat-tailed design causes increased barrel wear. The boat-tailed bullet design of Mk 8 ammunition is not in itself a problem. However, when combined with the cordite propellant used in Mk 8 cartridges, which burns at a much higher temperature than nitrocellulose, there is increased barrel erosion. The cumulative effects of firing Mk 8 ammunition through rifles were known of during the Second World War, and British riflemen were ordered to avoid using it, except in emergencies. The best general-purpose ammunition for any .303 military rifle is the Mark 7 design because it provides the best combination of accuracy and stopping power. There is no problem with using ammunition loaded with corrosive primers, providing that the gun is thoroughly cleaned after use to remove the potassium chloride salt deposits. Some Eastern Bloc countries still use corrosive primers in the manufacture of ammunition. [edit] Commercial ammunition  Commercial ammunition for weapons chambered in .303 British is readily available, as the cartridge is still manufactured by major producers such as Remington, Federal, Winchester, Sellier & Bellot and Wolf. Reloading equipment and ammunition components are also manufactured by companies such as Hornady. Where extreme accuracy is required, the Sierra Matchking 174-grain (11.3 g) HPBT bullet is a popular choice. Commercially-produced ammunition is widely available in various FMJ, soft point, hollow point, flat-based and boat tail designs—both spitzer and round-nosed. The classic 174-grain (11.3 g) FMJ bullets are widely available, though purchasers may wish to check whether or not these feature the tail-heavy Mk 7 design. In any case other bullet weights are available e.g. 150, 160, 170, 180 and 200-grain (13 g), both for hunting and target purposes. [edit] Weapons chambered for .303 British
[edit] See also
[edit] References
[edit] External links
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| ↑ top of page ↑ | about thumbshots |
